ADF front side skew adjustment (Second step)
1 Determine which correction to apply.
1 To correct, rotate the ADF adjustment screw clockwise.
2 To correct, rotate the ADF adjustment screw counterclockwise.
Note: One 360‑degree turn of the ADF adjustment screw equals approximately 0.4 mm of skew correction.
2 Remove the ADF rear cover. See “ADF rear cover removal” on page 598.
3 Remove the flatbed glass cushion. See “Flatbed glass cushion removal” on page 632.
4 Loosen the three nuts and four screws (A) securing the adjusting bracket to the ADF frame, as shown.
5 Rotate the ADF adjustment screw (B) to correct the skew.
6 After the skew has been corrected, tighten the three nuts and the four screws, and reinstall the ADF rear cover.
7463
Repair information
399
To Next Page
Loading...
