3 Once the cleaning process is done, select Continue.
4 When the Scanner Calibration Reset Action has Passed message displays, press the cancel button
on the keypad to exit.
5 Power off the unit.
Registering the front ADF and back ADF
1 Perform a print quick test.
Navigate to Configuration mode > Scanner Manual Registration > Print Quick Test.
2 The following Quick Test target page is printed:
Note: Make sure the margin spacing on the target page is uniform all the way around the target. If it is not, the
printer margins may need to be reset.
Note: 110V units print letter size while 220V units print A4 size.
7463
Repair information
406
To Next Page
Loading...
