d Make adjustments as needed, and then select Submit.
e Load the target page in the ADF tray facing up, and then select Copy Quick Test to check the results.
f Repeat steps a through e until the copy is evenly spaced on the top and both sides.
Note: Once a test page with evenly spaced margins is generated, keep the copy as an aid in setting the ADF
magnification.
12 When both the front and backside ADF has been registered, power the unit off, and then retune the flatbed
magnification. See
“Retuning the flatbed magnification (code P132 or greater)” on page 413.
7463
Repair information
411
To Next Page
Loading...
