Lexmark MX710 - Page 2

Item Return Program cartridge
Africa, Middle East, Central Eastern Europe (non‑EU), and Commonwealth of Independent States (CIS)
Toner Cartridge 625
High Yield Toner Cartridge 625H
Extra High Yield Toner Cartridge
625X
*
*
This toner cartridge is supported only in the MX711 printer model.
For more information on countries located in each region, visit
www.lexmark.com/regions.
Item Regular cartridge
Worldwide
High Yield Toner Cartridge
620HA
1
Extra High Yield Toner Cartridge
620XA
2
1
This toner cartridge is supported only in the MX710 printer model.
2
This toner cartridge is supported only in the MX711 printer model.
Ordering an imaging unit
Extremely low print coverage for extended periods of time may cause imaging unit parts to fail prior to exhaustion of toner.
For more information on replacing the imaging unit, see the instruction sheet that came with the supply.
Part name Lexmark Return Program Regular
Imaging unit 520Z 520ZA
Ordering a maintenance kit
To identify the supported fuser type, view the label on the fuser. Do either of the following:
• Remove the toner cartridge and imaging unit. The two-digit fuser type code (such as 00 or 01) can be seen on the front of
the fuser.
Warning—Potential Damage: Do not expose the imaging unit to direct light for more than 10 minutes. Extended
exposure to light may cause print quality problems.
• Pull down the printer rear door. The two-digit fuser type code (such as 00 or 01) can be seen on the rear of the fuser.
Notes:
• Using certain types of paper may require more frequent replacement of the maintenance kit.
• The separator roller, fuser, pick rollers, and transfer roller are all included in the maintenance kit and can be individually
ordered and replaced if necessary.
• For more information on replacing the parts included in the maintenance kit, see the instruction sheet that came with
each part.
Supplies guide
Page 2 of 3