29. Install the encoder wheel. 30. Take the OPC drum and lightly coat with your preferred
Lexmark drum lubricant. Place the OPC drum into the cartridge
with the long thin axle on the contact or non-chip side of the
cartridge. Make sure that the spring is in the proper position.
31. Install the drum axle plate and two screws as shown. 32. On the opposite side of the cartridge, install the black
plastic bushing. Turn it until it locks. Press on the white gear
inside the bushing.
LEXMARK T650 SERIES • TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
3232 West El Segundo Blvd., Hawthorne, California 90250 USA • Ph +1 424 675 3300 • Fx +1 424 675 3400 • techsupport@uninetimaging.com • www.uninetimaging.com
© 2009 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not warrant downloaded information.
To Next Page
Loading...
