Lexmark X658DFE - Page 105

Diagnostic information 2-71
7462
Go Back
Previous
Next
28x.54
x = bin
number
Eject motor encoder
not detected
Applies to:
StapleSmart finisher
The eject motor encoder
detection is lost during normal
operation.
1. Check all the connections on
the output option controller
card.
2. Replace the output option if
problem remains.
28x.55
x = bin
number
Eject motor
overspeed failure
Applies to:
StapleSmart finisher
The eject motor rotate at the
specified speed
1. Check all the connections on
the output option controller
card.
2. Replace the output option if
problem remains.
28x.56
x = bin
number
Eject motor
underspeed failure
Applies to:
StapleSmart finisher
The eject motor rotate at the
specified speed
1. Check all the connections on
the output option controller
card.
2. Replace the output option if
problem remains.
28x.57
x = bin
number
Sensor (stapler pass
through) static jam
Applies to:
StapleSmart finisher
Media remains on the sensor
(stapler pass through) during
the warm up sequence.
Go to sensor (stapler pass
through) static jam service
check.
See “Sensor (stapler pass
through) static jam service
check” on page 2-146.
28x.58
x = bin
number
Sensor (stapler pass
through) late jam
StapleSmart finisher
The media is late reaching the
sensor (stapler pass through)
within the specified time.
See “Sensor (output pass
through) late jam service
check” on page 2-146.
28x.59
x = bin
number
Staple ready home
position jam
Applies to:
StapleSmart finisher
The sensor (self priming) within
the stapler unit assembly does
not detect a ready staple in the
specified time after the staple
job was sent.
1. Check all the connections on
the controller card and the
stapler assembly.
2. Remove the staple cartridge
and remove all jammed
staples. If the cartridge is
jammed and can not be
removed, go to step 3.
3. Remove the stapler
assembly.
Go to “MFP stapler assembly
stapler unit assembly
removal” on page 4-207.
4. Manually rotate the drive
gears and reset the stapler.
Remove all jammed staples
then reinstall the stapler
assembly.
5. If problem remains, replace
the stapler assembly.
Go to “MFP stapler assembly
stapler unit assembly
removal” on page 4-207.
28x.60
x = bin
number
The status of stapler
motor is not defined
Applies to:
StapleSmart finisher
A software failure has occurred
with the output option.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
Error
code or
message
Error contents Description/Action Possible repair actions