84 Photoconductor low
1 Press the up or down arrow button until Continue appears, and then press .
2 Order a replacement photoconductor immediately. When print quality is reduced, install the new photoconductor.
84 Replace photoconductor
The printer will not print any more pages until the photoconductor is replaced.
Replace the specified photoconductor.
84 Photoconductor abnormal
An unacceptable photoconductor has been installed in the device. Replace the photoconductor.
88 Cartridge low
The toner is low. Replace the print cartridge, and then touch Continue to clear the message and continue printing.
88 Replace cartridge to continue
Replace the toner cartridge.
298.01 Scanner Missing - Cable Unplugged
The scanner was not detected. Make sure the scanner is properly connected.
1565 Emulation error, load emulation option
The printer automatically clears the message in 30 seconds and then disables the download emulator on the firmware
card.
To fix this, download the correct download emulator version from the Lexmark Web site at www.lexmark.com.
Clearing jams
Jam error messages appear on the control panel display and include the area of the printer where the jam occurred.
When there is more than one jam, the number of jammed pages is displayed.
Avoiding jams
The following hints can help you avoid jams:
Paper tray recommendations
•
Make sure the paper lies flat in the tray.
• Do not remove a tray while the printer is printing.
Troubleshooting 233
To Next Page
Loading...
