USB
Setup troubleshooting
For additional Setup troubleshooting information, see the Troubleshooting
chapter of the User’s Guide.
Incorrect language
appears on the display.
1 Press to turn the printer off.
2 Press once, and then immediately press and hold
and .
3 Release the buttons.
4 Press or repeatedly until the language you
want appears on the display.
5 Press or repeatedly until the option for
Country is highlighted.
6 Press or repeatedly until the country or region
you want appears on the display.
7 Press or repeatedly until Set Date and Time
is highlighted.
8 Press .
9 Set the date and time. For more information, see step
5 in the Setup documentation.
Software does not
install.
1 Turn off and then restart the computer.
2 Click Cancel on all New Hardware screens.
3 Insert the CD, and then follow the instructions on the
computer screen to install the software.
If the Install screen does not appear:
1 Insert the CD.
2 Click Start Æ Run.
3 Typ e D:\Setup, where D is the letter of the CD-ROM
drive.
4 Click OK.
Power button is not lit. 1 Disconnect the power cord from the wall outlet and
then from the printer.
2 Plug the cord all the way into the power supply on the
printer.
3 Plug the cord into an electrical outlet that other
electrical devices have been using.
4 If the light is not on, press .
To Next Page
Loading...
