Error codes Error message Solution
11.92 Load multipurpose feeder
with <type/> <size/>
<orientation/>.
Open the multipurpose feeder, and
then load paper. For more
information, see
“Loading the
multipurpose feeder” on page 52.
12.11, 12.21, 12.31, 12.41, 12.51 Change <source/> to <type/>
<size/>.
Open the indicated tray, remove
paper, and then load the correct
paper type and size. For more
information, see
“Loading trays” on
page 49.
12.12, 12.22, 12.32, 12.42, 12.52 Change <source/> to <type/>
<size/> <orientation/>.
Open the indicated tray, remove
paper, and then load the correct
paper type and size. For more
information, see
“Loading trays” on
page 49.
12.91 Change multipurpose feeder
to <type/> <size/>.
Remove paper, and then load the
correct paper type and size. For more
information, see
“Loading the
multipurpose feeder” on page 52.
12.92 Change multipurpose feeder
to <type/> <size/>
<orientation/>.
Remove paper, and then load the
correct paper type and size. For more
information, see
“Loading the
multipurpose feeder” on page 52.
29.08 Reminder: Remove packaging.
1 Open door A, and then remove
the packing material inside the
printer.
2 Pull out each of the three red
clips starting with the upper left,
lower left, and ending on the right
side.
3 Close door A.
4 Open door B.
5 Pull the red loop on the right side
straight out.
6 Close door B.
31.30 Transfer module problem.
Restart printer.
1 Turn
o
the printer, and then
unplug the power cord from the
electrical outlet.
2 Connect the power cord to the
electrical outlet, and then turn on
the printer.
CAUTION—POTENTIAL
INJURY: To avoid the risk of fire
or electrical shock, connect the
power cord to an appropriately
rated and properly grounded
electrical outlet that is near the
product and easily accessible.
Troubleshoot a problem 264
To Next Page
Loading...
