Adjusting Sleep mode
1 From the home screen, navigate to:
> Settings > General Settings > Timeouts > Sleep Mode
2 In the Sleep Mode field, select the number of minutes the printer is idle before it enters Sleep mode.
3 Apply the changes.
Using Hibernate mode
Hibernate is an ultra‑low‑power operating mode.
Notes:
• Three days is the default amount of time before the printer enters Hibernate mode.
• Make sure to wake the printer from Hibernate mode before sending a print job. A hard reset or a long
press of the Sleep button wakes the printer from Hibernate mode.
• If the printer is in Hibernate mode, then the Embedded Web Server is disabled.
1 From the home screen, navigate to:
> Settings > General Settings
2 From the “Press Sleep Button” or “Press and Hold Sleep Button” menu, select Hibernate, and then touch
Submit.
Adjusting the brightness of the printer display
To save energy, or if you have trouble reading from the display, adjust the brightness of the display.
Using the Embedded Web Server
1
Open a Web browser, and then type the printer IP address in the address field.
Notes:
• The IP address is located on the upper portion of the home screen. It appears as four sets of
numbers separated by periods, such as 123.123.123.123.
• If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2 Select Settings > General Settings.
3 In the Screen Brightness field, enter the brightness percentage you want for the display.
4 Apply the changes.
Using the control panel
1
From the home screen, navigate to:
> Settings > General Settings
2 In the Screen Brightness
field,
enter the brightness percentage you want for the display.
3 Apply the changes.
Saving money and the environment 230
To Next Page
Loading...
Need help?
General
