Replace last scanned page and jammed originals if restarting job.
Try one or more of the following:
• Tou ch Cancel job to clear the message and cancel the scan job.
• Tou ch Scan from automatic feeder to continue scanning from the ADF immediately after the last
successful scan job.
• Tou ch Scan from flatbed to continue scanning from the scanner immediately after the last successful
scan job.
• Tou ch Finish job without further scanning to end the last successful scan job.
• Tou ch Restart job to restart the scan job with the same settings from the previous scan job.
Replace maintenance kit, recommended life exceeded [80.xy]
The printer is scheduled for maintenance. For more information, go to http://support.lexmark.com or
contact your service representative.
Replace maintenance kit to resume printing [80.xy]
The printer is scheduled for maintenance. For more information, go to http://support.lexmark.com or
contact your service representative.
Replace missing cartridge [31.xy]
Install the missing cartridge to clear the message. For more information, see “Replacing the toner cartridge”
on page 242.
Replace missing fuser [80.xx]
1 Install the missing fuser. For more information, see the instruction sheet that came with the replacement
part.
2 From the control panel, touch Supply replaced to clear the message.
Replace missing imaging unit [31.xy]
Install the missing imaging unit. For more information, see the instruction sheet that came with the supply.
Replace roller kit [81.xx]
Try one or more of the following:
• Replace the roller kit. For more information, see the instruction sheet that came with the part.
• From the printer control panel, select Continue to clear the message and continue printing.
Troubleshooting 278
To Next Page
Loading...
