ELECTRICAL COMPONENTS
455
64L013
2. Make sure the inoperative component is turned off. Pull
the suspected fuse straight out with the pull−out tool and
check it. If it has blown, push a new fuse into the clips.
64G008a
"Good "Blown
a. Look carefully at the fuse. If the thin wire is broken, the fuse
has blown. If you are not sure or if it is too dark to see, try
replacing the suspected fuse with one of the same value that
you know is good.
b. Only install a fuse with the amperage rating designated on
the fuse box lid.
If you do not have a spare fuse, in an emergency you can pull
out the “DOME” or “CIG” fuse, which may be dispensable for
normal driving, and use it if its amperage rating is the same.
If you cannot use one of the same amperage, use one that is
lower, but as close to the rating as possible. If the amperage
is lower than that specified, the fuse might blow out again but
this does not indicate anything wrong. Be sure to get the
correct fuse as soon as possible and return the substitute to its
original clips.
To Next Page
Loading...
Need help?
General
