546
3-5. Using the hands-free system (for cellular phone)
LS460_EE
When another Bluetooth
®
device is connected during registering or select-
ing a phone
When another Bluetooth
®
device is connected, a confirmation message will
be displayed. If you want to disconnect it, touch “Yes”.
When Bluetooth
®
audio is connected while registering a phone
When you register your phone, Bluetooth
®
audio will disconnect. It will
reconnect automatically when you finish registration. It will not be recon-
nected depending on the phone you are using.
Connecting the phone while Bluetooth
®
audio is playing
Bluetooth
®
audio will disconnect. It will reconnect automatically when you
finish connecting the phone. It will not be reconnected depending on the
phone you are using.
Setting the “Handsfree power”
The mode changes between on and off every time you select “Handsfree
power” on the “Connect telephone” screen. When “Handsfree power” is on,
the Bluetooth
®
phone is automatically connected when you turn the
“ENGINE START STOP” switch is in ACCESSORY or IGNITION ON
mode.
Editing the “Device name”
If you change a device name, the name registered in your cellular phone is
not changed.
About “Device address”
The address peculiar to the system. You cannot be changed. If you have reg-
istered two Bluetooth
®
phones with the same device name and you cannot
distinguish one from the other, refer to this address.
When you delete a Bluetooth
®
phone
The phonebook data will be deleted at the same time.
To Next Page
Loading...
