17 300781309_002_C0 - 01/2019 - © Leybold
Measurement
8. Press the "MES" button to start gas analysis. The "S" and "M" lights come on.
(Whether the F, R and S lights are on or off depends on the settings on the control
panel.)
9. To terminate gas analysis, press the "MES" button again.
10.Turn off the "FIL" button and then turn off the analyzer tube filament.
11.Exit the software when measurement is completed.
4.2 Using the sensor unit
Refer to the operation manual supplied on the software installation CD.
To Next Page
Loading...
