First of all, it needs to do the pairing between outdoor remote sensor and wall
clock. Please follow below procedures to pair the sensor.
1. Insert 4 new “AA” batteries into the wall clock.
The screen is turned on. It starts to search sensor and register the received
sensor. During pairing, the signal strength indicator will animate until the
sensor signal is received or for 3 minutes if no signal available.
Please select the correct time zone before RCC search.
2. Slide the switch to CH1 of the outdoor sensor and Insert 2 new “AAA”batteries.
The wireless remote sensor will transmit the signal and LED will flash during
transmission.
Note : If no sensor(s) is paired, you can pair the sensor(s) again manually by
pressing and holding the CHANNEL key for 3s. Please refer to “10 SEARCH FOR
OUTDOOR SENSOR”.
5
PAIR THE OUTDOOR REMOTE SENSOR
4 FIRST TIME TO USE
To Next Page
Loading...
