Please select the correct time zone in order to display correct time accordingly.
5
4.1 PAIR THE OUTDOOR REMOTE SENSOR
4 FIRST TIME TO USE
First of all, it needs to do the pairing between outdoor remote sensor and wall
clock. Please follow below procedures to pair the sensor.
1. Insert 3 new “AA” batteries into the wall clock.
The screen is turned on. It starts to search sensor and register the received
sensor. During pairing, the signal strength indicator will animate until the
sensor signal is received or for 5 minutes if no signal available.
Note: If no sensor(s) is paired, you can pair the sensor(s) again manually by
pressing and holding the [CHANNEL] key for 3 seconds. Please refer to
“9 SEARCH FOR OUTDOOR SENSOR”.
2. Slide the switch to CH1 of the outdoor sensor and Insert 2 new“AAA”
batteries. The wireless remote sensor will transmit the signal and LED will flash
during transmission.
16
To Next Page
Loading...