14
9
8.3 DEACTIVATE/ACTIVATE ALARM
8.4 SWITCHING OFF THE ALARM SIGNAL
8.5 SNOOZE FUNCTION
• When the alarm is ringing, press any buttons except 【 Light/Snooze】to
stop the alarm signal . It is not necessary to reactivate the alarm. It will ring
again this time next day.
• When the alarm rings, press 【 Light/Snooze】button to pause the alarm.
The snooze indicator icon keep flashing.
• The alarm will resume after 8 minutes.
• Press
【 Max/Min】
to display the maximum value of temperature/humdity
readings. 【 】icon will shown beside humidity reading.
• Press
【 Max/Min】
again to display the minimum value of temperature/
humdity readings.【 】icon will shown beside humidity reading.
• Press and hold
【 Max/Min】
over 2 seconds to re-record the maximum &
minimum value of the temperature & humidity.
• The memory of maximum & minimum value will be cleared at every 0:00am.
• The weather symbols indicate the weather fluctuation over the next 6-12 hours,
not the current weather.
• Please take the weather forecast from your local weather forecasting service
into account as well as the forecast from your weather station. If there are
1
1
11
• Press the
【 Up/ 】
to select the Alarm1 and Alarm 2 ON or OFF.
• If the alarm is on, its corresponding alarm icon ( and ) will be shown on
the display.
• Alarm 1 icon is shown on display, it means Alarm 1 is turned on.
• Alarm 2 icon is shown on display, it means Alarm 2 is turned on.
• Alarm 1 and Alarm 2 icon are shown on display, it means Alarm 1 and
Alarm 2 are turned on.
9 TO VIEW MAX/MIN TEMPERATURE & HUMIDITY DATA
RECORD
10 WEATHER FORECAST FUNCTION
11
11
To Next Page
Loading...
