EXTERNALEQUIPMENT SETUP
VCRSETUP
m
x
.-t
m
z
m
JC)
c
m
z
.-t
m
c
To avoid picture noise (interference), leave an adequate distance between the VCR and TV.
If the 4:5 picture format is used; the fixed images on the sides of the screen may remain visible on the
screen. This phenomenon is common to all manufactures and in consequence the manufactures warranty
does not cover the product bearing this phenomenon.
When connecting with an antenna
Wall Jack
Antenna
1. How to connect
Connect the RF antenna out socket of the VCR to the ANTENNA/CABLE IN socket on the set.
Connect the antenna cable to the RF antenna in socket of the VCR.
0
2. How to use
01_Set VCR output switch to 3 or 4 and then tune TV to the same channel number.
01_Insert a video tape into the VCR and press PLAY on the VCR. (Refer to the VCR owner's manual.)
22
To Next Page
Loading...
