2) DIGITAL DATA 256Byte
4.8. HDCP SETTING
(High-Bandwidth Digital Contents Protection)
1) Connect D-sub Signal Cable to D-Sub Jack.
2) Input HDCP key with HDCP-key- in-program.
3) HDCP Key value is stored on EEPROM(AT24C64) which is
E00~F20 addresses of 0xBC~0xBE page.
4) AC off/ on and on HDCP button of MSPG925 and confirm
whether picture is displayed or not of using MSPG925.
5) HDCP Key value is different among the sets.
4.9. Outgoing condition Configuration
1) After all function test., press IN-STOP Key by SVC Remote
controller. And Make Ship Condition.
2) When pressing IN-STOP key by SVC remocon, Green and
red LED are blinked alternatively. And then Automatically
turn off. (Must not AC power OFF during blinking)
4.10. Internal pressure
- Confirm whether is nomal or not when between power
board's ac block and GND is impacked on 1.5kV(dc) or
2.2kV(dc) for one second.
4.11 Option data setting (SVC OSD setting)
(1) PAL Model (Change by Suffix)
- 12 -
Option1
1 200PR No
2 ACMS YES
3 TEXT FLOF TOP / FLOF
4 CH+AU 0 0 : Except below area
1 : China, Australia
5 BOOSTER No AGC Threshold point
Option2
1 SYS No BG/IDK/L
2 A2 ST YES Acting FM-ST after checking Nicam
3 I II SAVE No
4 HDEV No
5 V-CURVE No
6 MONO No
Option3
1 KEY-TYPE 2 8 key
Option4
1 Default Lang 3
2 Lang 0 English Deutsch French Italiano
Spanish Nederlands Svenska
Norsk Dansk Suomi
Portuguese Romaneste Polski
Magyar Chesky ΡУССКИЙ
3 T-Lang 0 AUSTRIA BULGARIA CROATIA
CZECH DENMARK ENGLAND
ESTONIA FINLAND FRANCE
GERMANY GREECE HUNGARY
ITALY LATVIA NETHERLANDS
NORWAY POLAND PORTUGAL
RUMANIA RUSSIA SERBIA
SLOVAKIA SLOVENIA SPAIN
SWEDEN SWITZERLAND
TURKEY ARAB HEBREW Others
Option5
1 2 HR-OFF Yes
2 TV-LINK-TUNER No
3 FACTORY MODE No
4 CHANNEL-MUTE Yes
No. Item Condition Remark
To Next Page
Loading...
