A-19
PREPARATION
BACK COVER FOR
WIRE ARRANGEMENT
■ Image shown may differ from your TV.
NOTE
►Do not use the Cable Management Clip to lift
the TV.
- If the TV is dropped, you may be injured or the
TV may be damaged.
Connect the cables as
necessary.
To connect additional
equipment, see the
EXTERNAL EQUIPMENT
SETUP section.
1
Open the Cable Management Clip as
shown.
2
Cable Management Clip
Fit the Cable Management Clip as shown.
3
■ Image shown may differ from your TV.
When installing the wall-mounted unit,
use the protection cover.
NOT USING THE
DESK-TYPE STAND
Insert the Protection
Cover into the TV until
clicking sound.
Protection Cover
ATTACHING THE TV TO A
DESK
(Only 32/37/42LD4
***
, 26/32LD32
**
,
26/32LD33
**
)
Desk
Stand
■ Image shown may differ from your TV.
The TV must be attached to desk so it cannot
be pulled in a forward/backward direction,
potentially causing injury or damaging the
product. Use only an attached screw.
WARNING
►To prevent TV from falling over, the TV
should be securely attached to the floor/wall
per installation instructions. Tipping, shaking,
or rocking the machine may cause injury.
1-Screw
( provided as parts of the product)
To Next Page
Loading...
