8
ENG
ENGLISH
INSTALLATION MENU
Power Management
Determines hours of no activity before automatic
shutoff. The POWER MANAGE function is for
saving energy. If set to No, Power Manage is
disabled. Settings range from 1 ~ 7, representing
the hours that the unit will remain On, unless
there has been activity from either the control
panel or remote control. Setting is retained in non-
volatile memory.
Setting
The setting is a value between 1 and 7
corresponding to the number of hours desired.
Key Management
If set to 1, key defeat prevents the end user from
accessing the on-screen menus with the display
front panel-SETTINGS button do not function.
Note: The menus can always be accessed by
pressing MENU button on the remote.
Key management when enabled determines
the level of control that the guest has over the
television. Key management has five modes:
(default is ‘0’)
0 = Television is unrestricted and responds to
all commands.
1 = "Key defeat”prevents the television from
responding to “MENU”key presses on the
front panel.
2 = “Key Lock”prevents the television from
responding to any front panel key press.
3 = “System provider”mode allows access to
the menu system from the front panel or
remote control but access is controlled as
follows
* Accessible items on the menu system
- Main/PIP input select screens
- Sleep Timer
- Aspect Ratio
- Closed Caption
- Full access “Lock”
→
Q.menu, related to “Setup Menu”, is not
accessible either.
4 = “Key defeat” prevents the TV from
responding to a “MENU” button pressed
on the front panel and remote control.
5 = “No access Remote/Front panel” prevents
the TV from responding to any button
pressed on the front panel and remote
control.
NOTE
: You must set the Auto Off option to
off in the Time menu to prevent the TV set
from being turned off automatically.
Setting is retained in non-volatile memory.
Factory Reset
Set to 0 for normal.
Set to 1 to load presets to all of the previous item
settings and exit menu.
WARNING: Setting this to 1 will reload the factory
defaults.
Setting is retained in non-volatile memory.
Aspect Ratio
Selects default aspect ratio at power up, see
settings below.
Set to 0 to disable. Aspect Ratio will stay at
previous state.
Set to 1 “Set By Program”.
Set to 2 for 4:3.
Set to 3 for 16:9.
Setting is retained in non-volatile memory.
Item Enable Disable Initial
Public Display Mode Yes No No
Power On default Yes No No
Input Source TV-MAX_INPUT TV
Tune Mode Virtual/Physical Physical
Major No. Subject to Ch. Type 2
Minor No. Subject to Ch. Type 0
Aux Input Source Setting
Yes No No
Input Source
Aux Input (AV1-Max_Input)
AV1
Setting Enable / Disable Enable
Minimum Volume 0 ~ 100 0
Maximum Volume 0 ~ 100 100
Start Volume Yes No No
Level 0 ~ 100 20
Power Management Yes No No
Setting 1 ~ 7 1
Key Management 0 ~ 5 0
Factory Reset 0 ~ 1 0
Aspect Ratio 0 ~ 3 0
To Next Page
Loading...
