Removing the Front IR
The Front IR Item 510 on the parts breakdown is
under a wire routing bracket Item 511.
p/n: EBR72671001
Remove the cable wire from the wire routing
Remove the one Screw and disconnect the connector.
Slide the wire routing bracket to the right to allow the
bracket to pull forward.
rac
e
an
remove
e w
re rou
ng
rac
e
Item 511 on the parts breakdown.
Wire routing
Tab
rac
e
,
e
g
After gaining access to the Front IR/Intelligent Sensor
gn
Board, lay the TV down on its face and remove the LCD
Panel by removing the screws around the perimeter of the
panel. Lift the Panel up and out.
The Front Frame / key board is attached to the Front Frame.
It must be removed to be replaced.
Part number: EBR72671001
May 2011 LCD TV 42LV5500
39