LG 49LS73D - HDMI IT Contents] S N; Upnp Mode] S N, 9 C; Model Name Check] F V; Analog Signage BLU Setting S N, C2

ENGLISH_index
65
99. [HDMI IT Contents] (Command: s n, 99)
Uses HDMI data to automatically set Picture Mode.
Transmission
(s)(n)( )(Set ID)( )(9)(9)( )(Data)(Cr)
Data 00: Off
01: On
Acknowledgement
(n)( )(Set ID)( )(OK/NG)(9)(9)(Data)(x)
* This feature may not be supported for some models.
100. [UPnP Mode] (Command: s n, 9c)
Sets the desired UPnP mode.
Transmission
(s)(n)( )(Set ID)( )(9)(c)( )(Data)(Cr)
Data 00: Off
01: On
Acknowledgement
(n)( )(Set ID)( )(OK/NG)(9)(c)(Data)(x)
* This feature may not be supported on some models.
* If the UPnP Mode is changed, a reboot will occur.
101. [Model Name check] (Command: f v)
Checks the Model Name.
Transmission
(f)(v)( )(Set ID)( )(Data)(Cr)
Data FF: Check product serial number
Acknowledgement
(v)( )(Set ID)( )(OK/NG)(Data)(x)
* Data is in hexadecimal ASCII code.
102. [No Signal Image] (Command: s n, a9)
Turns No Signal Image On or Off.
Transmission
(s)(n)( )(Set ID)( )(a)(9)( )(Data)(Cr)
Data 00: Off
01: On
Acknowledgement
(n)( )(Set ID)( )(OK/NG)(a)(9)(Data)(x)
* This feature may not be supported on some models.
103. Wi-Fi (Command: s n, 9f)
Set up Wi-Fi.
Transmission
(s)(n)( )(Set ID)( )(9)(f)( )(Data)(Cr)
Data 00: Enable
01: Disable
Acknowledgement
(n)( )(Set ID)( )(OK/NG)(9)(f)(Data)(x)
* This feature may not be supported on some models.
104. Analog Signage BLU Setting (Command: s n, c2)
Set up Analog Signage BLU.
Transmission
(s)(n)( )(Set ID)( )(c)(2)( )(Data)(Cr)
Data 00: Off
01: On
Acknowledgement
(n)( )(Set ID)( )(OK/NG)(c)(2)(Data)(x)
* This feature may not be supported on some models.