ENGENGLISH
9
INSTALLATION PROCEDURE / ASSEMBLING AND PREPARING
INSTALLATION PROCEDURE
1
Open the package and make sure all the accessories are included.
2
Attach the stand to the TV set.
3
Connect an external device to the TV set.
4
Make sure the network connection is available.
You can use the TV network functions only when the network connection is made.
*
When the TV is turned on for the first time after being shipped from the factory, initialization of
the TV may take approximately one minute.
ASSEMBLING AND PREPARING
Unpacking
Check your product box for the following items. If there are any missing accessories, contact the
local dealer where you purchased your product. The illustrations in this manual may differ from the
actual product and item.
Do not use any unapproved items to ensure the safety and product life span.
Any damages or injuries by using unapproved items are not covered by the warranty.
The screens of some models are covered by a thin film. Do not remove it.
CAUTION
The items supplied with your product may vary depending
upon the model.
Product specifications or contents of this manual may be
changed without prior notice due to upgrade of product
functions.
For an optimal connection, HDMI cables and USB devices
should have bezels less than 10 mm thick and 18 mm width.
Use an extension cable that supports USB 2.0 if the USB cable
or USB FLASH DRIVE does not fit into your TV’s USB port.
Use a certified cable with the HDMI logo attached. If you do not use a certified HDMI cable,
the screen may not display or a connection error may occur.
Recommended HDMI cable types (3 m or less)
- High-Speed HDMI
®
/
TM
cable
- High-Speed HDMI
®
/
TM
cable with Ethernet
NOTE
B
A
A
B
*A 10 mm
*B 18 mm
To Next Page
Loading...
Need help?
General
Weight and Dimensions
