LG 65EV960H - Page 57

57
206-4322
IP Environment Setup (Cont.)
Conguring a Wired Network Connection
Note: If desired, you can congure both wired and wireless
connections. However, note that a wired connection is always
prioritized over a wireless connection. That is, when the TV is turned
OFF and then back ON, if a Local Area Network (LAN) is detected
by the TV, the TV will default to the wired connection. If the LAN
cable is removed, the TV will then attempt to establish the wireless
connection. Whenever the TV is reconnected to the LAN, the TV will
re-establish the wired connection.
1. Connect the appropriate cable between the TV and the network.
2. With the Network Menu on display, use the arrow keys on the
Installer Remote to select Network Setting. Then, press the
Wheel (OK) button. A second Network screen (see example at
right), with Wired and Wi-Fi Connection setup options, will be
displayed.
By default, the TV uses DHCP, and if a LAN is detected, the TV
will request an IP address from the DHCP server on the network
as soon as you select “Network Setting” above. If the TV is able
to connect to the network, a “Connected to Internet” message will
be displayed below the Wired Connection eld.
3. If the network is not congured for DHCP or you want to
specify static IP conguration data or you would like to change
the network conguration from Manual to Automatic, edit the IP
data for this TV as follows:
• In the second Network screen, select Wired Connection and
press the Wheel (OK) button. Then, in the Wired screen, select
Edit (if not already selected) and press the Wheel (OK) button.
• In the Edit IP screen, select or de-select the “Set Automatically”
checkbox, as required. A checkmark indicates that Automatic
conguration is enabled.
• To manually edit the IP data, for each data entry eld: Use the
arrow keys on the Installer Remote to select the eld and press
the Wheel (OK) button. You can use the number keys on the
Installer Remote to direct enter numeric values or use the arrow
keys to select the appropriate numbers from the pop-up virtual
keyboard displayed at the bottom of the screen. (Note, however,
that you must use the dot “.” key from the virtual keyboard to
separate each octet of an IP address.) When you are done,
select Enter from the virtual keyboard, and then press the
Wheel (OK) button on the Installer Remote.
• When all Edit IP elds are set as required, use the arrow keys
on the Installer Remote to select Connect and press the
Wheel (OK) button.
At the top of the screen, you will see a progress display that
indicates status as each network element is conrmed (see
example at right).
NETWORK SETT...
Network /
Wired Connection (Ethernet)
Not Connected
Wi-Fi Connection
Not Connected
Network
Pro:Centric
Media Share
Pre-loaded
Apps
EDIT IP
Network / Network Setting / Wired Connection (...
Connected to Internet
Set Automatically
IP Address
Subnet Mask
Gateway
DNS Server
CONNECT
Network
Pro:Centric
Media Share
Pre-loaded
Apps
WIRED
Network / Network Setting /
Connected to Internet
IP (Automatic)
IP Address 10.1.2.4
Subnet Mask 255.255.255.0
Gateway 10.1.2.3
DNS Server 10.1.2.3
MAC Address C8:08:E9:40:49:F5
EDIT
Network
Pro:Centric
Media Share
Pre-loaded
Apps
DNS
(Continued on next page)
10.1.2.4
DNS
10.1.2.3
10.1.2.3
255.255.255.0