LG 65EV960H - Importing a Clone File

45
206-4322
Cloning Procedures (Cont.)
(Continued from previous page)
X
USBDEVICE
EXPORT
Select the filename, and then select EXPORT below.
xxEV960H-UA_1.TLX
<
>
TV MANAGER
Export Clone File
USB 1: Device Name
Ez Download
Update TV Software
Update PTC Software
Import Clone File
Export Clone File
Diagnostics
Export progress will be displayed on the screen. This process may take a few minutes.
Do NOT remove the USB device while exporting is in progress. When the export process is
complete, an EXPORT COMPLETE pop-up banner will be displayed at the bottom of the
screen.
11. Press the Wheel (OK) button to return to the TV Manager screen. To return to program viewing,
select the
X
button at the top right corner of the screen.
12. Remove the USB memory device from the Master TV.
Note: If the Master TV has a channel lineup, during the export process, logical
channel numbers are automatically assigned in ascending order, starting with 0
(zero), to the physical RF channels of the TV channel lineup to create an FTG
Channel Map. See also note below.
Note: If the exported Clone file is to be used for FTG Mode configuration (i.e., it
contains an FTG Channel Map), it is highly recommended that you open the file in
the Cloud Configuration Tool—BEFORE transferring (importing) the file to any
Target TVs—to verify FTG Channel Map and FTG Installer Menu settings. This will
also enable you to confirm channels and add channel attributes, labels, etc.
Importing a Clone File
This section describes how to transfer (import) a Clone or Conguration (.tlx) le from a USB
memory device to a TV using the TV Manager “Import Clone File” option. The “.tlx” le may be
created either from a Master TV Setup that was saved (exported) from a Master TV or in the
Cloud Configuration Tool.
Before You Begin
• Ensure the USB device has been formatted with FAT format.
• Avoid using special characters, such as ?, &, @, etc., in the Clone/Conguration (.tlx) lename.
(Continued on next page)