LG 65EV960H - Page 64

64
206-4322
(Continued from previous page)
• To enable use of a randomly generated security key for SoftAP
access, set the Use Default eld to “Enable” (the Security Key
eld will subsequently be grayed out and the random security key
will be displayed).
• To specify your own security key for SoftAP access, set the Use
Default eld to “Disable.” Then, select the Security Key eld and
press the Wheel (OK) button. In the data entry eld, use the
number keys on the Installer Remote to direct enter a numeric
security key, or use the arrow keys to select the appropriate
alphanumeric characters—at least eight, but no more than 64—
from the pop-up virtual keyboard displayed at the bottom of the
screen. Note that the security key may not contain any special
characters (:, /, \, @, etc.). When you are done, select Enter from
the virtual keyboard, and then press the Wheel (OK) button on
the Installer Remote.
• Select the appropriate values in the Wi-Fi Signal Strength and
Wi-Fi Channel elds, as required.
4. If desired, you can specify a name for this TV so that it is easy
to identify and differentiate from other TVs for which sharing has
been/will be enabled.
Note: By default, the TV name is the TV’s serial number. However,
if a room number is specied in the EZ-Manager Wizard or in the
General Menu / Room Info screen, the TV name is changed to the
room number.
To edit the TV name, use the Up/Down arrow keys to select the TV
Name eld, and then press the Wheel (OK) button. You can then use
the number keys on the Installer Remote to direct enter a numeric
TV name, or you can use the arrow keys to select the appropriate
alphanumeric character(s) from the pop-up virtual keyboard at the
bottom of the screen. When you are done, select Enter from the
virtual keyboard, and then press the Wheel (OK) button on the
Installer Remote.
5. Once all elds are completed as required, use the arrow keys on the
Installer Remote to return to the IP Environment Menu, as necessary,
or press BACK/EXIT to exit the IP Environment Menu.
Note: While Smart Share, Screen Share, and Media Renderer settings
are clonable, DIAL and SoftAP settings, as well as the TV name cannot
be cloned.
IP Environment Setup (Cont.)