LG 65UW660H - Importing a Clone File

41
206-4297
Cloning Procedures (Cont.)
(Continued from previous page)
9. Modify the lename, as required. While the TV model element of the lename may not be
changed, you can differentiate this Clone le from other UW660H Clone les by changing
the numeric assignment appended to the end of the lename. Select/highlight the lename,
and then use the Up/Down arrow keys on the Installer Remote to scroll through numeric
assignments until the desired number is shown.
10. When you are ready to continue, i.e., when you have selected the desired lename, press
OK on the Installer Remote to select/activate the EXPORT button at the bottom of the screen,
and then press OK on the Installer Remote once more to export the le.
Export progress will be displayed on the screen. This process may take a few minutes.
Do NOT remove the USB device while exporting is in progress. When the export process is
complete, an EXPORT COMPLETE pop-up banner will be displayed at the bottom of the
screen.
11. Press OK to return to the TV Manager screen. To return to program viewing, select the
X
button at the top right corner of the screen.
12. Remove the USB memory device from the Master TV.
Note: If the Master TV has a channel lineup, during the export process, logical
channel numbers are automatically assigned in ascending order, starting with 0
(zero), to the physical RF channels of the TV channel lineup to create an FTG
Channel Map. See also note below.
Note: If the exported Clone file is to be used for FTG Mode configuration (i.e., it
contains an FTG Channel Map), it is highly recommended that you open the file in
the FTG File Manager—BEFORE transferring (importing) the file to any Target
TVs—to verify FTG Channel Map and FTG Installer Menu settings. This will also
enable you to confirm channels and add channel attributes, labels, etc.
Importing a Clone File
This section describes how to transfer (import) a Clone or Conguration (.tlx) le from a USB
memory device to a TV using the TV Manager “Import Clone File” option. The “.tlx” le may be
created either from a Master TV Setup that was saved (exported) from a Master TV or in the FTG
File Manager.
Before You Begin
• Ensure the USB device has been formatted with FAT format.
• Avoid using special characters, such as ?, &, @, etc., in the Clone/Conguration (.tlx) lename.
• If the EZ-Manager Wizard appears on the screen when you turn ON the Target TV, you can
use the wizard’s “USB Conguration” option to access the TV Manager and complete the import
procedure (see “TV Conguration Options” and/or “USB Conguration” on pages 14 and 20,
respectively, as necessary).
• You may also use the Ez Download utility to import the Clone/Conguration (.tlx) le. See “Ez
Download Utility” on pages 22 to 25 for further information.