LG 65UW660H - Remote Jack Pack; TV Connections & Setup

60
206-4297
Remote Jack Pack Setup
RJP Available? If you will use a Remote Jack Pack (RJP) in your system, set Installer Menu item 093
RJP AVAILABLE appropriately (for example, on a legacy model RJP: HDMI Mode, set RJP AVAILABLE
to 1). See Installer Menu detailed descriptions for further information.
093 RJP AVAILABLE 001
TV Connections
Caution: Make these connections ONLY after Master TV Setup and TV cloning procedures
are complete. Also, make sure to use the RJ-45 Control cable from the RJP cable bundle to
make the connection to the TV’s RJP port. Do NOT connect a standard Ethernet cable to the
RJP port, as this may damage the TV and network equipment.
Refer to the gure below, and connect the RJ-45 Control cable from the RJP cable bundle to the RJP port
on the TV’s rear jack panel. Then, connect HDMI and Composite Video/Audio connectors, as applicable,
for the cable bundle.
Reference: Remote Jack Pack / TV Connections & Setup
SPEAKER OUT
LINE OUT
PTC SERVICE
(SERVICE ONLY)
RJP
Use
Only
MPI
AV IN/
AUDIO IN (DVI)
ANTENNA /
CABLE IN
LAN
OPTICAL
DIGITAL
AUDIO OUT
USB IN 1
RESET
UPDATE
IN 1
SERVICE
L/MONO-AUDIO-R
RS-232C IN
(CONTROL)
HDMI IN 1
Connect HDMI connector
from RJP cable bundle.
RJP Use Only
Connect RJ-45 Control cable
from RJP cable bundle.
AUDIO/VIDEO IN
Connect Composite Video/Audio
connectors from RJP cable bundle.
(Composite Video on legacy RJP only.)
Note: RGB is not supported on these TV models. If an RGB source is connected to a legacy
RJP, you will see a brief message on-screen to indicate that this device is not supported.