LG 65UW660H - Page 58

58
206-4297
IP Environment Setup (Cont.)
(Continued from previous page)
3. If you would like to enable SoftAP, complete the SoftAP access
conguration as follows:
• Select/highlight SoftAP and press OK on the Installer Remote.
• When you initially access the SoftAP screen (see example at
right), the OFF/ON toggle button at the top right of the screen is
selected/highlighted by default. Press OK on the Installer Remote
to turn SoftAP ON.
• To enable use of a randomly generated security key for SoftAP
access, set the Use Default eld to “Enable” (the Security Key
eld will subsequently be grayed out and the random security key
will be displayed).
• To specify your own security key for SoftAP access, set the Use
Default eld to “Disable.” Then, select the Security Key eld and
press OK. In the data entry eld, you can use the number keys on
the Installer Remote to direct enter a numeric security key, or you
can use the arrow keys to select the appropriate alphanumeric
characters—at least eight, but no more than 64—from the pop-up
virtual keyboard displayed at the bottom of the screen. Note that
the security key may not contain any special characters (:, /, \, @,
etc.). When you are done, select Enter from the virtual keyboard,
and then press OK on the Installer Remote.
• Select the appropriate values in the Wi-Fi Signal Strength and
Wi-Fi Channel elds, as required.
4. If desired, you can specify a name for this TV so that it is easy
to identify and differentiate from other TVs for which sharing has
been/will be enabled.
Note: By default, the TV name is the TV’s serial number. However,
if a room number is specied in the EZ-Manager Wizard or in the
General Menu / Room Info screen, the TV name is changed to the
room number.
To edit the TV name, use the Up/Down arrow keys to select the
TV Name eld, and then press OK. You can then use the number
keys on the Installer Remote to direct enter a numeric TV name, or
you can use the arrow keys to select the appropriate alphanumeric
character(s) from the pop-up virtual keyboard at the bottom of the
screen. When you are done, select Enter from the virtual keyboard,
and then press OK on the Installer Remote.
5. Once all elds are completed as required, use the arrow keys on the
Installer Remote to return to the IP Environment Menu, as necessary,
or press
to exit the IP Environment Menu.
Note: While Smart Share, Screen Share, DMR, and Bluetooth Sound
Sync settings are clonable, DIAL and SoftAP settings, as well as the
TV name cannot be cloned.
MEDIA SHARE
Network
Pro:Centric
Media Share
Pre-loaded
Apps
Smart Share
Disable
Screen Share
Disable
DMR
Disable
Bluetooth Sound Sync
Disable
DIAL
Disable
TV Name
406KCEA6Q508
SoftAP
^
SOFTAP
Media Share /
Network
Pro:Centric
Media Share
Pre-loaded
Apps
ON
Use Default
Disable
Security Key
00000000
Wi-Fi Signal Strength
Not Used
Wi-Fi Channel
Auto
^
^
^
^
Notes:
• Screen Share MUST be enabled in
addition to Smart Share in order for
guests to use Wi-Fi Direct.
• If you enable Bluetooth Sound Sync,
a pop-up conrmation banner will be
displayed since enabling Bluetooth
Sound Sync renders Wireless LG
Sound Sync unavailable. Select
Yes to continue.
^
^
^
^
^