LG 65WU960H - Page 66

66
206-4335
IP Environment Setup (Cont.)
Conguring a Wired Network Connection
Note: If desired, you can congure both wired and wireless connections.
However, note that a wired connection is always prioritized over a
wireless connection. That is, when the TV is turned OFF and then back
ON, if a Local Area Network (LAN) is detected by the TV, the TV will
default to the wired connection. If the LAN cable is removed, the TV will
then attempt to establish the wireless connection. Whenever the TV is
reconnected to the LAN, the TV will re-establish the wired connection.
1. Connect the appropriate cable between the TV and the network.
2. With the Network Menu on display, use the arrow keys on the
Installer Remote to select Network Setting. Then, press the Wheel
(OK) button. A Network Setting screen (see example at right), with
Wired and Wi-Fi Connection setup options, will be displayed.
By default, the TV uses DHCP, and if a LAN is detected, the TV will
request an IP address from the DHCP server on the network as soon
as you select “Network Setting” above. If the TV is able to connect
to the network, a “Connected to Internet” message will be displayed
below the Wired Connection (Ethernet) eld.
3. If the network is not congured for DHCP or you want to specify
static IP conguration data or you would like to change the network
conguration from Manual to Automatic, edit the IP data for this TV
as follows:
• In the Network Setting screen, select Wired Connection (Ethernet)
and press the Wheel (OK) button. Then, in the Wired Connection
(Ethernet) screen, select Edit (if not already selected) and press
the Wheel (OK) button.
• In the Edit screen, select or de-select the “Set Automatically”
checkbox, as required. A checkmark indicates that Automatic
conguration is enabled.
• To manually edit the IP data, for each data entry eld: Use the
arrow keys on the Installer Remote to select the eld and press
the Wheel (OK) button. You can use the number keys on the
Installer Remote to direct enter numeric values or use the arrow
keys to select the appropriate numbers from the pop-up virtual
keyboard displayed at the bottom of the screen. (Note, however,
that you must use the dot “.” key from the virtual keyboard to
separate each octet of an IP address.) When you are done, select
Enter from the virtual keyboard, and then press the Wheel (OK)
button on the Installer Remote.
• When all Edit elds are set as required, use the arrow keys on
the Installer Remote to select Connect and press the Wheel (OK)
button.
At the top of the screen, you will see a progress display that indicates
status as each network element is conrmed (see example at right).
NETWORK SETT...
Network /
Wired Connection (Ethernet)
Not Connected
Wi-Fi Connection
Not Connected
Network
Pro:Centric
Portal Settings
Media Share
EDIT
Network / Network Setting / Wired Connection (...
Connected to Internet
Set Automatically
IP Address
Subnet Mask
Gateway
DNS Server
CONNECT
Network
Pro:Centric
Portal Settings
Media Share
WIRED CONN...
Network / Network Setting /
Connected to Internet
IP (Automatic)
IP Address 10.1.2.4
Subnet Mask 255.255.255.0
Gateway 10.1.2.3
DNS Server 10.1.2.3
MAC Address C8:08:E9:40:49:F5
EDIT
Network
Pro:Centric
Portal Settings
Media Share
DNS
(Continued on next page)
10.1.2.4
DNS
10.1.2.3
10.1.2.3
255.255.255.0