LG 65WU960H - Page 67

67
206-4335
IP Environment Setup (Cont.)
(Continued from previous page)
If the network is connected successfully, a “Connected to Internet” message will appear just
below the progress display. If the network connection is not successful, the progress display will
identify the network element in which the connection failed. Check your cabling and/or verify the
conguration data, as necessary.
4. Once the wired network conguration is complete, use the arrow keys on the Installer Remote to
return to the IP Environment Menu, as necessary, or press BACK/EXIT to return to the previous
Network Menu level(s) and/or exit the IP Environment Menu.
Conguring a Wi-Fi Network Connection
1. With the Network Menu on display, use the arrow keys on the
Installer Remote to select Network Setting. Then, press the Wheel
(OK) button.
2. A Network Setting screen (see example at right), with Wired and
Wi-Fi Connection setup options, will be displayed. Select Wi-Fi
Connection and press the Wheel (OK) button.
3. In the Wi-Fi Connection screen, available access points are listed in
the top half of the screen, while additional menu options are listed
below. Use the arrow keys on the Installer Remote to select the
desired access point, or select the type of wireless connection to
congure (see bullets below). Then, press the Wheel (OK) button.
• Hidden network: Direct enter the SSID of an access point whose
SSID has not been enabled for broadcast (i.e., the access point
does not appear in the list of access points).
• WPS PBC: Connect to a network via an access point that is
enabled for PBC.
• WPS PIN: Complete network/PIN verication via the access point
web interface.
Make sure you have the network security password/PIN available if
you are attempting to connect to a secured network.
4. Follow the on-screen instructions to complete the appropriate
network conguration. Use the Installer Remote to navigate between
elds and make entries, etc.
Note: As with a wired connection, you will have the option to specify
static IP conguration data for this network connection. Once the
initial connection is established, you can select Advanced Wi-Fi
Settings (initially greyed out) at the bottom of the Wi-Fi Connection
screen to view the IP conguration data. In the Advanced screen,
select Edit and press the Wheel (OK) button, and then modify the
IP data, as required. See step 3 of the wired connection procedure
above for further information on the Edit screen elds.
5. Once the wireless network conguration is complete, use the
arrow keys on the Installer Remote to return to the IP Environment
Menu, as necessary, or press BACK/EXIT to return to the previous
Network Menu level(s) and/or exit the IP Environment Menu.
NETWORK SETT...
Network /
Wired Connection (Ethernet)
Not Connected
Wi-Fi Connection
Not Connected
WI - FI CONN...
Network / Network Setting /
AAA
BBB
CCC
DDD
EEE
Add a hidden wireless network
Connect via WPS PBC
Connect via WPS PIN
Advanced Wi-Fi Settings
Network
Pro:Centric
Portal Settings
Media Share
Network
Pro:Centric
Portal Settings
Media Share