44
MAINTENANCE
6
You can clean the inside of the small roller by
inserting a flat-head screwdriver into the
groove and removing the fixing part.
7
Reassemble the small roller and the fixing part
and make sure that they are properly attached.
8
When holding both ends of the rotating brush
and pulling it out, the rotating brush and part
of the edge will separate. If hair is wrapped
around the edge of the rotating brush, remove
the rotating brush and clean it.
9
Reassemble the rotating brush and the part of
the edge and insert the end of the rotating
brush into the groove at the end of the nozzle.
10
Slide the brush back into the nozzle until it
clicks into place.
Cleaning the Pet Nozzle
1
Press the nozzle release button
a
to remove
the nozzle from the extension pipe or product
body.
2
Remove the rotating brush while holding down
the
PUSH
button on the nozzle.
3
Attach the crevice tool to the product body and
use the vacuum to remove foreign objects and
dust from the brush and the bottom of the
nozzle.
4
Use a damp towel or cloth to remove any
remaining foreign objects and dust from the
brush and the bottom of the nozzle. Remove
To Next Page
Loading...
Need help?
General
