10
ENGLISH
PRODUCT INTRODUCTION
Handling the remote control
- Aim at the signal receptor on the floor standing type air
conditioner when operating.
- Block a strong light over the signal receptor with a curtain or
etc. so as to prevent the abnormal operation. (ex: electronic
quick start, ELBA, inverter type fluorescent lamp)
- Be sure that there are no obstructions between the remote
control and the signal receptor.
- Do not drop or throw the remote control.
- Do not place the remote control in a location exposed to
direct sunlight, or next to a heating unit, or other heat
source.
* Some function does not operate according to model.
Control
panel
Description
Remote control operation lamp
|
Power ON/OFF button : Operation will start
when this button is pressed, and stop when
the button is pressed again.
Indoor fan speed button : To select the desired
fan speed.
Temperature setting button
A
Cooling button
Auto dry button : If setting this function,
evaporator will be automatically dried before
turning off the air conditioner.
D
Dehumidification button : Can effectively
remove humidity when at the time of rainy
season or high humidity.
Artificial intelligence
Fan mode button
Air flow direction button(Up/down, Left/right) :
Adjust air flow direction vertically or
horizontally.
Power cooling mode button : Powerful cooling
is performed
ON/OFF timer setting button : Set the time of
starting or stopping
Timer cancel button
4
FAN SPD
Wireless remote controller
< Type1 >
To Next Page
Loading...
