LG APNQ30GS1K1 - Dehumidification Mode; Power Cooling;Heating Mode

14
ENGLISH
OPERATING INSTRUCTIONS
Dehumidification Mode
In rainy season or high humidity climate, it is
possible to operate simultaneously
dehumidifier and cooling mode to remove
humidity effectively.
1 Press button to turn on the indoor.
2 Press c button to select dehumidification
mode
- Room temperature will be displayed after
desired temperature is indicated at
display section for about 5 seconds.
Power Cooling/Heating Mode
Strong cooling/heating will be conducted in
short time.
1 Press button to turn on the indoor.
2
Press button to operate power
cooling/heating mode.
- When power (cooling/heating) button is
pressed during cooling/dehumidification
mode, power cooling will be operated.
In power cooling mode, desired
temperature is set to 18°C and the
horizontal louver is fixed at the highest
position.
- When power (cooling/heating) button is
pressed during heating operation, power
heating will be operated.
In power heating mode, desired
temperature is set to 30°C and the
horizontal louver is fixed at the lowest
position.
Fan Mode
1 Press button to turn on the indoor unit.
2 Press
4
button on remote controller to
circulate indoor air.
- When canceling operation, press
4
button once more.
- During fan mode, outdoor fan and
compressor will not be operated.
- During fan mode, indoor unit turns on the
fan speed lamp and room temperature
lamp of its display panel.
Simple Reservation
This function is able to turn on unit after a
setting time.
1 When the unit is turned off, adjust desired
setting time with button.
- Up to the maximum of 24 hours can be
selected.
This function is able to turn off unit after a
setting time.
1 When the unit is turned on, adjust desired
setting time with button.
- Up to the maximum of 7 hours can be
selected.
Turning OFF reservation mode
Turning ON reservation mode
Heat Pump
NOTE
!
After performing the setting, if corresponded
setting button is pressed once, remaining
setting time will be displayed, and if it is
pressed once again, corresponded setting
function will be cancelled. (same function as
) Remaining setting time will be displayed
with the unit of 1 hour.