LG APNQ30GS1K1 - Wireless remote controller

10
PRODUCT INTRODUCTION
ENGLISH
Handling the remote control
- Aim at the signal receptor on the floor standing type air conditioner when operating.
- Block a strong light over the signal receptor with a curtain or etc. so as to prevent the abnormal
operation. (ex: electronic quick start, ELBA, inverter type fluorescent lamp)
- Be sure that there are no obstructions between the remote control and the signal receptor.
- Do not drop or throw the remote control.
- Do not place the remote control in a location exposed to direct sunlight, or next to a heating unit, or
other heat source.
- The feature may be changed according to the type of model.
- Some functions may not be supported, depending on the model.
Control
panel
Description
Remote control operation lamp
|
Power ON/OFF button : Operation will start when this
button is pressed, and stop when the button is pressed
again.
Indoor fan speed button : To select the desired fan
speed.
Temperature setting button
A
Cooling button
B
Heating button
Auto dry button : If setting this function, evaporator will
be automatically dried before turning off the air
conditioner.
D
Dehumidification button : Can effectively remove
humidity when at the time of rainy season or high
humidity.
C
Artificial intelligence
Fan mode button
Air flow direction button(Up/down, Left/right) : Adjust air
flow direction vertically or horizontally.
Power cooling/heating mode button :
Powerful cooling and heating are performed
ON/OFF timer setting button : Set the time of starting or
stopping
Timer cancel button
4
FAN SPD
Wireless remote controller