Getting Started12
Getting Started
1
2. When you mount the wall bracket on a wall
(concrete), use the wall bracket to check the
point to drill. Then you should drill some holes.
3. Remove the WALL BRACKET INSTALL GUIDE.
4. Fix it with screws (not supplied) as shown in the
illustration below.
Screws and anchors are not supplied for
mounting the unit. We recommend the
FAB31058701 screw and MEG62598701 anchor
for the mounting. Please purchase them.
,
Note
5. Hang the main unit onto the brackets, as shown
below.
y
Do not hang onto the installed unit and
avoid any impact to the unit.
y
Secure the unit rmly to the wall so that it
does not fall o. If the unit falls o, it may
result in an injury or damage to the product.
y
When the unit is installed on a wall, please
make sure that a child does not pull any of
connecting cables, as it may cause it to fall.
>
Caution
Detach the unit from the bracket as shown
below.
,
Note
CM2820-DM.DDEULLK-6258-ENG.indd 12 2012-04-19 4:00:52
To Next Page
Loading...
Need help?
General
