Operating 17
Operating
2
Radio Operations
Antenna Connection
Connect the FM Wire antenna to FM ANTENNA
connector.
Be sure to fully extend the FM wire
antenna. After connecting the FM wire
antenna, keep it as horizontal as possible.
,
Note
Listening to the radio
1. Press FUNCTION until FM appears in the display
window.
The last received station is tuned in.
2. Auto tuning : Press and hold TUNING (-/+) for
about 2 seconds until the frequency indication
starts changing, then release. Scanning stops
when the unit tunes in a station.
Manual tuning : Press TUNING (-/+) repeatedly.
3. Adjust the volume by pressing VOL (+/-).
Presetting the Radio Stations
You can preset 50 stations for FM . Before tuning,
make sure to turn down the volume.
1. Press FUNCTION until FM appears in the display
window.
2. Select the desired frequency by pressing
TUNING (-/+).
3. Press PROGRAM/MEMORY. A preset number
will blink in the display window.
4. Press PRESETFOLDER
W
/
S
to select the
preset number you want.
5. Press PROGRAM/MEMORY. The station is
stored.
6. Repeat steps 2 to 5 to store other stations.
7. To listen a preset station, press
PRESETFOLDER
W
/
S
.
Deleting all the saved stations
1. Press and hold PROGRAM/MEMORY for two
seconds. “ERASEALL” will blink on the display
window.
2. Press PROGRAM/MEMORY to erase all saved
radio stations.
Improving poor FM reception
Press
d
/
M
on the remote control. This will change
the tuner from stereo to mono. Then the reception
will be better than before.
CM2820-DM.DDEULLK-6258-ENG.indd 17 2012-04-19 4:00:53
To Next Page
Loading...
Need help?
General
