LG CM9750 - Page 41

3-22
ONE POINT REPAIR GUIDE
NO SOUND
There is no sound output in the TUNER function, repair the set according to the following guide.
10-4. TUNER FUNCTION
10-4-1. Solution
Replace IC201, TU500 on MAIN board.
10-4-2. How to troubleshoot (Countermeasure)
1) Check if TUNER_L/R is entered from pin1 & 3 of TU500 to IC201(pin26, 27).
 If no signals, Check +3.3 V for Tuner power.
 Check if the Tuner control signals (CLK, DAT, CE, RST, GPO2) are entered from IC501 to TU500.
If it doesn’t work, replace TUNER with a new one.
2) Check if ADC_BCK, ADC_LRCK & DAC_MCLK are entered from IC501 to IC201.
3) Check if ADC_DATA is entered from IC201 to IC501.
 If no signal, check +5 V & +3.3 V (ADC) for IC201. If is NG, replace it a new one.
4) Check the following I2S audio signal flow from IC501 to IC202.
 If there is any trouble, check the power for each IC. The power is normal but, if the signal waveform to
the IC is distorted or no signal, replace it with a new one.
5) Check if the digital audio AMP block is okay.
 If AMP is damaged, replace it with a new one.
10-4-3. Service hint (Any picture / Remark)
{TG
IC501
MLC3730
IC202
PS9860
PWM
MCS_BCK
MCS_LRCK
{
IC201
CS5346
TUNER
ADC/MIC_DATA
MCS_MCLK
TUNER_L/R
IR AMP
IRS2092+IRF6775
Jack
Board
MIX_DATA_OUT
< TUNER function signal fl ow >
< MAIN board bottom view >
IC201
IC201
ADC/MIC_DATA to R212
ADC/MIC_DATA to R212
MCS_BCK to R213
MCS_BCK to R213
MCS_LRCK to R215
MCS_LRCK to R215
MCS_MCLK to R216
MCS_MCLK to R216
TUNER_L/R
TUNER_L/R