POWER ON
VFD “NO DISC” status
It is possible at any function.
(ex. It is possible at VFD “NO USB” status, too.)
This is an example.
Front ‘STOP’ + Remote control “ ”
push same timing during 5s
FLD “OP00-…..”
Move to appropriate position
And make changes
with RMC “ , , , REPEAT” key.
Press STOP Key
VFD “WRITE OK”
Front ‘STOP’ + Remote control “ ”
push same timing during 5s
VFD “E2P CLR”
Completed
1-7
SERVICE INFORMATION FOR EEPROM
To Next Page
Loading...
