16
3
Clean the exhaust lter with a brush or running
water.
•
To maintain cleaning performance, remove
the dust from the exhaust lter at least once a
month.
•
Allow the exhaust lter to dry out of direct
sunlight in a well-ventilated place. Reinstalling
the lter before it is completely dry may result
in mildew or odor.
4
Clean the pre-lter with a brush or running
water.
•
Allow the pre-lter to dry out of direct sunlight
in a well-ventilated place. Reinstalling the
lter before it is completely dry may result in
mildew or odor.
•
The more often the lters are cleaned, the
more optimal the suction power will be.
•
Filters are consumables. Please purchase
more lters from an authorized service center.
5
Reassemble the pre-lter rst. Then align the
exhaust lter with the hollow circle at top and
turn the lter clockwise until the solid white
circles align.
WARNING
•
Never wash the product body or separator with
water. Water may reach the motor and cause
electric shock or re.
•
Keep foreign objects away from the motor to avoid
product damage, explosion or re.
•
Do not insert ngers or sharp objects into the motor
enclosure to avoid product damage, personal
injury, or electric shock.
CAUTION
•
Make sure to reattach the exhaust lter and pre-
lter to the product after washing them. Using
the product without these lters will allow dust
to reach the motor inside the product and cause
malfunction.
Note :
•
Dust buildup reduces the suction power, so for best
results, make sure the lters are clean each time
you use the product.
※
Removing foreign objects from inside
the product
In order to maintain product performance, be sure
to remove any foreign objects and dust from inside
the product (body, extension pipe, inlets). Foreign
materials inside the product can cause the product to
shut down during operation, generate noise, or cause
poor suction.
Product body
Foreign objects
Product body Pre-lter
Pre-lter
Foreign
objects
Foreign
objects
Extension pipe Inlet port
Foreign
objects
Foreign
objects
※
If the inside of the product body, extension pipe, or
inlet port is clogged with foreign objects, the power
automatically turns off to protect the product.
Separate the battery from the product and remove
the foreign objects.
MFL69883611_en_180523.indd 16 2018-05-23 오후 12:26:36
To Next Page
Loading...
Need help?
General
