15
Maintenance
Emptying the Dust Bin
1
Remove the battery from the unit before
cleaning the dustbin.
2
Hold the dust bin over a wastebasket or trash
can.
3
Press the release button at the bottom front of
the dust bin to open the bin and shake to empty
it.
•
Be careful as dust/foreign matter may spill out
when you open the dustbin.
Release button
4
Insert the crevice tool into the large dust
separator and turn it counterclockwise to
remove it.
5
Rinse the large dust separator under running
water and allow to dry completely before
reinstalling.
•
Be sure to dry the separator completely
before using it.
Large
dust
separator
6
With the dust separator removed, use the
combination tool to clean out the dust inside the
dustbin.
Combination Tool
WARNING
•
Never wash the product body with water. Water
may reach the motor and cause electric shock or
re.
•
Do not apply force or any impact to the dust bin
parts or the dust separator as it may damage them.
•
Reassemble the dust separator before using the
product. Failure to do so will damage the product.
Cleaning the Filters
The pre-lter and exhaust lter need to be cleaned
at least once a month to maintain the cleaning
performance of the product. The frequency of
cleaning depends on where and how often you use
the product. Clean the lters more often if used in
areas with a lot of dust.
1
Turn the outer exhaust lter counterclockwise to
remove it. Lift out the pre-lter by the handle.
Exhaust lter
Pre-lter
2
Use the brush attachment to clean off the motor
inside the lter compartment. Do not use water.
Combination
Tool
MFL69883611_en_180523.indd 15 2018-05-23 오후 12:26:35
To Next Page
Loading...
Need help?
General
