16
Installing the Charging
Station
Floor Standing Installation
Install the charging station on a hard and level
floor.
WARNING
• To prevent tipping, floor standing mode
installations should be anchored to the wall
using the provided stand anchoring screw,
anchoring block and double-sided tape.
CAUTION
• Keep fingers away from pinch points when
assembling the appliance or the charging
station.
• Do not allow children or pets to hang onto
the charging station. They could be injured or
cause damage to the appliance.
• Take care not to drop the product parts while
unpacking them to avoid appliance damage or
personal injury.
• Do not use double-sided tape to attach the
charging station to wallpaper. The weight of the
charging station and the product body could
damage the paper.
1
Remove the protective film attached to the
charging station, the product body, and the
nozzle.
• Failure to remove the film may affect
product performance.
2
Place the floor stand dock b on a hard and
level floor and assemble the floor stand pipe
a.
• Once assembled, the floor stand dock
and the floor stand pipe cannot be
disassembled.
3
Clip the power cord tidily into the cord keeper
c on the back of the floor stand pipe.
To Next Page
Loading...
Need help?
General
