18
INSTALLATION
• Turn the centre screw clockwise to raise the rear
of the tub and counterclockwise to lower it.
• To avoid damaging the screw, do not use an
electric screwdriver.
Case 1. The Door is Slanted to the
Right
1
Unscrew (counter-clockwise) the front left leg
and correct the level.
2
Check the opening of door and repeat if
necessary until the door opens and closes
properly.
Case 2. The Door is Slanted to the
Left
1
Unscrew (counter-clockwise) the front right leg
and correct the level.
2
Check the opening of door and repeat if
necessary until the door opens and closes
properly.
Securing Door Panel to
Dishwasher
Adjusting Appliance Height
1
Adjust the height of the appliance so the top of
the door is as close to the height of the
surrounding cabinet doors or drawer fronts as
possible.
2
Measure the difference in height (X mm)
between the top of the dishwasher door and
the tops of the surrounding cabinet doors or
drawers.
3
Using the measurement from step 2, make a
mark (X mm) up from the bottom of both rulers
at the top of the provided installation template.
To Next Page
Loading...
Need help?
General
