57
TROUBLESHOOTING
ENGLISH
Odour The previous cycle was stopped before completion and residual water
remains in the appliance.
• Turn on the power, run the
Cancel
cycle option to remove the residual
water, then run the
Turbo
cycle using detergent but with the appliance
empty.
There is food in the bottom of the unit or in the filter.
• Clean the filter and the interior according to the
MAINTENANCE
section of
the owner’s manual.
Unwashed dishes are left in the unit for a long time.
• Cycle with one cup of white vinegar in a appliance safe glass or bowl placed
on the upper rack. (Vinegar is an acid, and with constant use it could
damage your appliance.)
Food soil remains on
dishes.
Improper cycle selection
• Select correct cycle based on soil level and type of dishware being washed.
Water temperature is too low.
• Check water supply connection or water heater setting.
Dishwashing detergent was not used.
• Use recommended detergent.
Low inlet water pressure
• Water pressure should be between 0.05 - 0.6 MPa.
Water jet holes on spray arms blocked.
• Clean the spray arms.
Improper loading of dishes.
• Make sure dishes do not block spray arm rotation or interfere with
detergent dispenser.
Filters are clogged.
• Clean filters.
Too much unremoved food debris on dishes.
• Large particles of food residues should be removed from the dishes before
staring wash.
Symptoms Possible Cause & Solution
To Next Page
Loading...
Need help?
General
