TROUBLESHOOTING
TROUBLESHOOTING
Before Calling For Service
Your dryer is equipped with an automatic error-monitoring system to detect and diagnose problems at an early
stage. If your dryer does not function properly or does not function at all, check the following before you call for
service.
Dryer will not
turn on
plugged in.
breaker has tripped, or power
outage has occurred.
grounded outlet matching the dryer’s rating plate.
fuse capacity. If the problem is a circuit overload, have it
corrected by a qualified electrician.
Dryer does not
heat
breaker has tripped, or power
outage has occurred.
fuse capacity. If the problem is a circuit overload, have it
corrected by a qualified electrician.
shutoff are both fully open.
Greasy or dirty
spots
on clothes
dried together.
fabric softener.
because dirty items can soil clean clothes placed in the
same or subsequent loads.
removed during the washing process.
Make sure that clothes are being completely cleaned
according to the instructions for your washer and
detergent.
Display shows
Lint on clothes
some loads that produce high amounts of lint, it may be
necessary to clean the filter during the cycle.
clothes.
Excess static in
clothes after
drying
incorrectly.
press, or synthetic blends.
Do not use fabric softeners or products to eliminate static
unless recommended by the manufacturer of the fabric
softener or product.
electricity. Adjust settings and use a shorter drying time,
or use SENSOR DRY cycles.
softener.
To Next Page
Loading...
Need help?
General
