LG DLEX3370 series - Cycle Modifier Buttons

45
ENGLISH
TROUBLESHOOTING
Before Calling For Service (cont.)
  
Steam does not
generate but
no error code is
shown
 
Garments still
wrinkled after
™

of garments in dryer.


There are no
creases left on
garment after
™

remove wrinkles from fabric.

Garments have
static after
REDUCE STATIC
 
Garments are
too damp or
too dry after
REDUCE STATIC

selected.

STATIC option.
Garments are
not uniformly
damp after
EASY IRON

Number of garments or load
size not properly selected at the
beginning of the cycle.

starting the cycle.
Water drips
from door
during Steam
Cycle
 
dryer door during steam operation. Some condensation
may drip out the bottom of the door.
Steam is not
visible during
Steam Cycle
 

the dryer door if the steam system is operating normally.
Drum does not
turn during
Steam Cycle
 

once a minute.
Cannot see
steam vapor at
the beginning
of cycle
 
option.
MFL67731035_en_140818.indd 45 2014.8.18 9:37:38 AM