LG F14U2TDHN - Troubleshooting; 7-1.Check before Service; 7-2.Load Test Mode

1
No Check Point
Turn on all lights and lock the door
Tumble clockwise
Tumble counterclockwise
Wash Heater turns on
Circulation Pump turns on
Drain Pump turns on
Dry Heater turns on
Off
Low speed spin
High speed spin
Pre-Inlet Valve turns on
Main-Inlet Valve turns on
Dry Valve turns on
Steam Valve turns on
Clean Valve turns on
2
3
4
5
6
7
8
9
10
11
12
13
14
15
22
Before servicing ask the customer what the trouble is.
Check the adjustments. (Power supply :220-240V~, Removal of transit bolts etc..)
Check the troubles referring to the troubleshooting.
Decide service steps referring to disassembly instructions.
Then, service and repair.
After servicing, operate the appliance to see whether it works OK or NOT.
7.TROUBLESHOOTING
7-1. CHECK BEFORE SERVICE
7-2. LOAD TEST MODE
1
Turn on, and touch ‘Wash’ and ‘Rinse’
at the same time in 1 second.
2
The washer must be empty and the controls must be in the off state.
3
Press Power with above two buttons pressed and then buzzer will sound.
4
Press the Start/Pause button repeatedly to cycle through the test modes.
1
2
3
4
5
6