48
V ~ U (8~11Ω)
U ~ W (8~11Ω)
W ~ V (8~11Ω)
Motor Stator
U V W
Hall Sensor
Ha
Hb
Common
Common ~ Ha (5~15kΩ)
Common ~ Hb (5~15kΩ)
1
Remove the Back Cover.
2
After loosening the Bolt, Rotor, pull out the
Rotor.
1
Remove the 6 Bolts from the Stator.
2
Disconnect the 2 Connectors.
1
Remove the Hinges (Damper) at the Tub.
3
The Hinge at the Base is pulled off.
(In directions of the arrow)
2
The Hinge(Damper) at the Base is pulled off by
pressing on the snaps at the sharp end.
ROTOR ASSEMBLY, STATOR ASSEMBLY, FRICTION DAMPER
To Next Page
Loading...
