A11
Troubleshooting
Check the following before calling for service.
NO SIGNAL message.
The signal cable is not connected, or is loose. Check and secure the connection.
The power LED is illuminated amber.
The frequency of the signal from the video card is outside the operating range of
the monitor.
* Horizontal Frequency : 30-96kHz
* Vertical Frequency : 50-160Hz
Use the graphics board's utility software to change the frequency setting (Refer
to the manual for graphics board).
Display power management mode.
There is no active signal coming from the PC.
The signal cable is not fastened securely.
Check the computer power and graphics adapter configuration.
The image on the SCREEN is not centered, or too small, or not a
rectangle shape.
Image adjustment not been done yet in the current operating mode. Use the
OSD, SET and buttons to set the image to your liking.
The monitor doesn't enter the power saving off mode (Amber).
Computer video signal is not VESA DPMS standard. Either the PC or the video
controller card is not using the VESA DPMS power management function.
To Next Page
Loading...
